>> BREU SERIES CAM CLUTCHES
Lubrication
BREU series Cam Clutches need periodic maintenance and lubrication to both bearing to provide maximum performance throughout their service life. Lack ofprescribed mantenance and lubrication will shorten the service life of Cam Clutch and may cause unnecesary mechanical damage.
Recommended Grease
Oil Company |
Ambient Temperature |
|
- 5°C ~ + 40°C |
- 40°C ~ + 40°C |
|
Esso |
Beacon 2 |
Beacon 325 |
Mobil |
Mobilux Grease No.2 |
Mobil temp SHC 100 |
Shell |
Alvania Grease No.2 |
Alvania Grease RA |
BP |
Energrease LS2 |
Enargrease LT2 |
TOTAL |
Multis 2 |
Aerogrease 22 |
Note :- Do not use Grease that contains EP additives.
E1 ~ E7 options are supplied with bolts for installation, and the grease nipple.
General Information for Installation and Usage
Maintenance
BREU series Cam Clutches are pre-greased at the factory ad should be re-greased every three months for both bearings after installation. Follow the procedure below.
- Remove the set screw at the flange, torque arm or cover.
- Inject equal amounts of grease into the bearing from the grease nipple. Refer to the grease volume table for the correct amount.
- Run the Cam Clutch disengaged for from 20 to 30 minutes with the set screw removed. Excess of grease in the clutch area will flow out of the tapped holes. Be careful to avoid over greasing. Too much grease in the clutch will cause it to run hot, interfere with the clutch action, and may lead to mechanical damage.
- Wipe off excess of grease and re-install the set screw.
Grease volume table
Model |
Each bearing (g) |
BREU 30 |
10 |
BREU 35 |
10 |
BREU 40 |
15 |
BREU 45 |
20 |
BREU 50 |
30 |
BREU 55 |
30 |
Model |
Each bearing (g) |
BREU 60 |
40 |
BREU 70 |
50 |
BREU 80 |
80 |
BREU 90 |
90 |
BREU 100 |
160 |
BREU 130 |
260 |
BREU 150 |
460 |